![]() ![]() Even if the glue holds, which if the strips are thin enough it likely would, by gluing one flat piece to one warped piece you'll get a thicker slightly less warped piece. If they're fur strips as mentioned in the post, how thick are they, how long, how wide? Again it makes a difference.Īlso keep in mind if your purpose is to get a straight board.that also will not work. If they're furring strips then they're probably pine and pretty flexible. I'm not sure if your talking about furring strips or fur strips. In between these scenarios are an infinite number of possibilities and so specifics need to be considered. A 23 factorial experiment was used to determine which factors and levels provide the optimal result flat, rather than warped, sheet stock in a full-line box plant located in the Southeast. Warping Boards (1 - 40 of 75 results) Price () Shipping Warping Board, 4.5 yard, Schacht Hardwood Warping Board MielkesFiberArts (10,872) 111.00 4.5 Yard Warping Board OakeandAshe (2,224) 66.00 FREE shipping Etsy’s Pick Hardwood Warping Board 4 1/2 or 9 Yard Beka Sturdy In Stock SUPER FAST SHIPPING TheSpinneryStore (8,992) 65. In fact if they are sufficiently thin you could bend them into a shape and glue them and they will hold the shape. Now if the strips you propose are very thin then yes the glue will hold. ![]() Even if the glue holds, the wood itself will fail and likely right alongside the glue line. For instance if your gluing 7" wide 1" thick maple boards edge to edge and hoping the glue will keep them together.nope, over time it will fail. Apply some heat to the other side of the board with a heat lamp, or just weigh the board down in the center and let it sit until dry.I don't think the question in the title is so easily answered. (Be careful of how much water you put on the board: if it is a glued up panel, copious amounts of water could weaken the glue joint, so go slow!) Now lay the board on a flat surface with the wet side down. ![]() Start by wiping the entire concave side with a wet towel. Another way to remove warp is to apply water and heat to different sides simultaneously.Clamp the board between two straight boards so that it will stay flat and air can circulate fully around it until it is completely dry. Move the towel and iron up the length of the board until it appears flat. The steam penetrates quickly into the wood fibers, causing the cupped or “short” side to expand. Lay a damp towel on the cupped or concave side and heat it with an iron. If the warp is not too pronounced, you can steam it out. ![]() Don’t try this if your room is very humid. If this takes care of the problem, sand and finish immediately-or, at the very least, wrap the board in something to protect it from the air. Let the board remain in this position overnight or longer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |